|
2020-09-21 14:28 developer |
|
|
|
Hi Emma, As explained on WECHAT that we found the adapter cannot be fit into the sample and need to revise the package design as attached. Plz kindly help update the artwork. 1. The giftbox size is enlarged 2. The carton size is enlarged 3. The qty placed on 1 pallet is reduced from 60pcs to 48pcs. So the qty in the container is modified as attached package proposal. Carton_520.02776.005_1119_v3.dwg (157,507 bytes) Giftbox_521.01610.005v3.dwg (61,150 bytes) |
|
|
Quick update on the sealing label shipped to you last time. As we verified it with the PE bag we found there is no need to add this label because the PE bag will not be opened easily after putting into the giftbox, so we will not keep it and verify again in DVT. Let me know if any questions. |
|
|
Hi Henry, Could you please reupload the carton dwg file? We cannot see anything when we opened it. Thank you. |
|
|
Hi Emma, Plz find attached needed file for carton drawing. We saved to another dxf file FYR. Carton_520.02776.005_1119_v3-2.dwg (157,507 bytes) |
|
|
Hi Henry, I checked the carton dwg file(v3 and v3-2) again, it also cannot see anything. So could you please give the original scale PDF file? The PDF file you already provided is not the original scale. Sorry for the inconvenience. |
|
|
Hi Emma, We tried to convert the dwg to 1:4 pdf then convert again to 1:1 in ai... Plz try this. Thanks |
|
|
Hi Emma, As mentioned yesterday the size is revised a little bit to fit in the giftbox. Update the drawing as attached. The scale is the same as above (We tried to convert the dwg to 1:4 pdf then convert again to 1:1 in ai...) Thanks |
|
|
Forget to share the PW: abc123 |
|
|
Hi Emma, I'd like to update on the 1st giftbox sample issues as attached. Plz feedback within this week so that we can implement into DVT2. At the same time we are working on the cost down version package proposal which will be provided within this week. I think we will need to make samples for reliability test after getting your confirmation afterwards and implement into MP. BTW the device label will use the 1st requested Pantone color version as we already prepared the materials before...let me know if any questions. Thanks, Henry |
|
|
Hi Emma, I'd like to provide the drawings of proposal 2 (cost down version) as attached. As discussed on WECHAT SWAN will go for proposal 2 for sure. Before we request for samples, plz help provide below info by 1/20 1. Update the artwork 2. Confirm the manufacturing spec proposal of inherent dot issue with Kraft paper Thanks Henry |
|
|
Hi Emma, I'd like to update the drawing 1:1 files as attached. Thanks Henry |
|
|
Hi Emma, I'd like to update the giftbox drawings as attached because we checked the structure samples and there are some modification needed. Plz help confirm quickly then we will proceed to request for samples. (qty is not confirmed by vendor yet...) Thanks Henry |
|
|
Hi Henry, Thank you for sharing the update. We have checked the files you shared, and there is no issue. Please proceed with it. Thank you. Best Regards, Emma LEE |
|
|
Because this project is in MP stage so I close it. |
- yk.jung ( (ALTech) Younkwang Jung ) developer
